Parts

No parts required.

Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.
  • Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.

With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.
  • With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.

  • The T8 Torx Security Bit Screwdriver can be substituted with a small flathead screwdriver. Screw removal may be slightly more difficult however.

New Battery = Faster iPhone
Fix Kits starting at $16.99
If needed, use the flathead screwdriver to gently pry the panel from the phone. Using your fingers, lift the panel from the device.
  • If needed, use the flathead screwdriver to gently pry the panel from the phone.

  • Using your fingers, lift the panel from the device.

Use your fingers to gently detach the ribbon wire from the logic board. Use your fingers to gently detach the ribbon wire from the logic board. Use your fingers to gently detach the ribbon wire from the logic board.
  • Use your fingers to gently detach the ribbon wire from the logic board.

Use the flathead screwdriver to pry the logic board and keypad from the device. Use the flathead screwdriver to pry the logic board and keypad from the device.
  • Use the flathead screwdriver to pry the logic board and keypad from the device.

Use your thumb to peel the keypad from the device. Use your thumb to peel the keypad from the device.
  • Use your thumb to peel the keypad from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Christopher

Member since: 04/22/2010

90 Reputation

8 Guides authored

Team

Cal Poly, Team 16-6, Maness Spring 2010 Member of Cal Poly, Team 16-6, Maness Spring 2010

CPSU-MANESS-S10S16G6

4 Members

8 Guides authored

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 2,477