Introduction

This guide requires removing the casing and front wheels.

Parts

No parts required.

From the top view, remove each of the four pins that hold the casing in place. From the top view, remove each of the four pins that hold the casing in place.
  • From the top view, remove each of the four pins that hold the casing in place.

Add Comment

Slowly pull the casing up to remove it.
  • Slowly pull the casing up to remove it.

Add Comment

Using a Phillips 1 screwdriver, completely unscrew the 8mm screw located in the center of the wheel. Repeat this step for other wheels if needed.
  • Using a Phillips 1 screwdriver, completely unscrew the 8mm screw located in the center of the wheel. Repeat this step for other wheels if needed.

Add Comment

Carefully pull the wheel off of its axle.  Repeat for other wheels as necessary.
  • Carefully pull the wheel off of its axle. Repeat for other wheels as necessary.

Add Comment

Pull the top half of the suspension to unclip it. Pull the top half of the suspension to unclip it.
  • Pull the top half of the suspension to unclip it.

Add Comment

Remove the top clip along with the spring.
  • Remove the top clip along with the spring.

Add Comment

Pull up the bottom half of the suspension to unclip it. Pull up the bottom half of the suspension to unclip it.
  • Pull up the bottom half of the suspension to unclip it.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Maximiliano Cortes

Member since: 02/01/2015

355 Reputation

3 Guides authored

Team

Cal Poly, Team 6-30, Amido Winter 2015 Member of Cal Poly, Team 6-30, Amido Winter 2015

CPSU-AMIDO-W15S6G30

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 97