Introduction

The front cover can get chipped or scratched. In this case it should be replaced.

Image 1/1:
  • Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

Add Comment

Image 1/2: Image 2/2:
  • Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

Add Comment

Image 1/1:
  • Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

Add Comment

Image 1/1:
  • Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

Add Comment

Image 1/1: Use a Torx T-7 screwdriver to unscrew the two screws.
  • Next, you must remove the motherboard from the front screen.

  • Use a Torx T-7 screwdriver to unscrew the two screws.

Add Comment

Image 1/2: To do so, you must use the back end of the spudger to push out the two white tabs connected to the wire, that holds the motherboard and front cover together. Image 2/2: To do so, you must use the back end of the spudger to push out the two white tabs connected to the wire, that holds the motherboard and front cover together.
  • Before you can seperate the motherboard from the front cover, you must disconnect the wire connecting the two.

  • To do so, you must use the back end of the spudger to push out the two white tabs connected to the wire, that holds the motherboard and front cover together.

Add Comment

Image 1/1:
  • Once separated, use the spudger to pry around the edges of the outer casing.

Add Comment

Image 1/2: The screen and front cover are now disconnected. Image 2/2: The screen and front cover are now disconnected.
  • Apply pressure with thumbs to remove screen from inner casing.

  • The screen and front cover are now disconnected.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Trevor Foster

Member since: 04/18/2010

142 Reputation

3 Guides authored

Team

Cal Poly, Team 7-7, Maness Spring 2010 Member of Cal Poly, Team 7-7, Maness Spring 2010

CPSU-MANESS-S10S7G7

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 11

All Time: 4,020