Skip to main content

Fix Your Stuff

Right to Repair

Store

Introduction

Unfortunately, my iFixit kit has not yet arrived, so I had to use my Wiha drivers and generic spudger. This is pretty simple to do!

Parts

No parts specified.

  1. Remove the nine Phillips screws using a Philips 00 screwdriver Remove the nine Phillips screws using a Philips 00 screwdriver Remove the nine Phillips screws using a Philips 00 screwdriver
    • Remove the nine Phillips screws using a Philips 00 screwdriver

  2. SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits

    SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits
  3. Pry up the case carefully using a spudger. Make sure to not push the spudger in too far, as this could result in internal damage
    • Pry up the case carefully using a spudger.

    • Make sure to not push the spudger in too far, as this could result in internal damage

  4. Lift off the cover, and you're done!
    • Lift off the cover, and you're done!

Conclusion

To reassemble, place the bottom cover on and push until you hear a satisfying click. Keep doing this until the whole cover is secured. Then, screw all of the screws back in!

3 other people completed this guide.

[deleted]

Member since: 03/18/2018

1,065 Reputation

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 10

All Time: 831