Fix Your Stuff Community Store

Supersonic SC-777BT Touchscreen Sensor Replacement

Introduction

If your touchscreen does not respond to a finger or stylus, you need to replace the touchscreen sensor. As a prerequisite, use the motherboard replacement guide to reveal the touchscreen after opening the back.

What you need

  1. Supersonic SC-777BT Touchscreen Sensor Replacement, Touchscreen Sensor: step 1, image 1 of 2 Supersonic SC-777BT Touchscreen Sensor Replacement, Touchscreen Sensor: step 1, image 2 of 2

    • Pull the yellow ribbon cable to dislodge the screen from the plastic screen cover.

    Edit

  3. Supersonic SC-777BT Touchscreen Sensor Replacement: step 2, image 1 of 3 Supersonic SC-777BT Touchscreen Sensor Replacement: step 2, image 2 of 3 Supersonic SC-777BT Touchscreen Sensor Replacement: step 2, image 3 of 3

    • Tear the yellow tape in order to make the front and back covers free to disassemble.

    Edit

  4. Supersonic SC-777BT Touchscreen Sensor Replacement: step 3, image 1 of 3 Supersonic SC-777BT Touchscreen Sensor Replacement: step 3, image 2 of 3 Supersonic SC-777BT Touchscreen Sensor Replacement: step 3, image 3 of 3
    Tool used on this step:
    Tweezers
    $4.99
    Buy

    • Separate the two covers.

    • Put aside the white sheets.

    • Do not put the white sheets on any surface. Only keep them in the covers.

    • Use the tweezers to remove the sting glue and separate the glue from the sensor.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 10

All Time: 233