Image 1/2: Locating the Battery Image 2/2: Flip Computer Toward Yourself
  • Remove charging adaptor. Some charge may still be in the battery or computer. DO NOT touch connectors or copper yellow connector.

  • Locating the Battery

  • Flip Computer Toward Yourself

Add Comment

Image 1/1: Locate two switches with the word “lock” and “release” on them.
  • Releasing Battery

  • Locate two switches with the word “lock” and “release” on them.

Add Comment

Image 1/1: Push towards each other while simultaneously lifting up the battery in between the two switches.
  • Removing Battery

  • Push towards each other while simultaneously lifting up the battery in between the two switches.

Add Comment

Image 1/1: DO NOT touch connectors or copper yellow connector.
  • Remove charging adaptor. Some charge may still be in the battery or computer.

  • DO NOT touch connectors or copper yellow connector.

  • The key board is attached by a screw on the back.

  • The front cover also holds the keyboard assembly.

  • Remove the memory door to access the screw for the keyboard.

  • The screws for the memory door do not come out. they are held from falling out.

Add Comment

Image 1/1: Remove this screw.
  • Locate the screw that holds the keyboard assembly in place.

  • Remove this screw.

  • Size: L 6.7mm X D 1.9mm

Add Comment

Image 1/1: Making sure that you when you slide the wires out. You slide from the side opposite the solder connections.
  • Be careful of the keyboard wire connection.

  • Making sure that you when you slide the wires out. You slide from the side opposite the solder connections.

  • Flip computer over and open.

Add Comment

Image 1/3: When the front of the keyboard is about two inches up. Carefully, using the blue spudger, pull out and slightly up on the connector clip. Then remove the wire connector. Image 2/3: Gently lift the key board assembly up and out. Image 3/3: Gently lift the key board assembly up and out.
  • Gently pry the keyboard assembly from the front. (closest to the screen) With the blue spudger.

  • When the front of the keyboard is about two inches up. Carefully, using the blue spudger, pull out and slightly up on the connector clip. Then remove the wire connector.

  • Gently lift the key board assembly up and out.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 15

All Time: 196