Introduction

In order to remove the webcam safely, be sure to take out the battery first. The webcam is located under the plastic screen cover of the laptop.

Parts

No parts required.

Turn the laptop over and orient it as shown.
  • Turn the laptop over and orient it as shown.

Add Comment

Slide both latches to the center of the laptop in order to release the battery.
  • Slide both latches to the center of the laptop in order to release the battery.

Add Comment

Use your fingernail or a plastic tool to lift the battery. Rotate the battery up and away to remove from the laptop. Use your fingernail or a plastic tool to lift the battery. Rotate the battery up and away to remove from the laptop.
  • Use your fingernail or a plastic tool to lift the battery. Rotate the battery up and away to remove from the laptop.

Add Comment

Remove the four rubber circles using the spudger located on each corner of the laptop. Remove the four screws (Length: 7.7 mm) using the Phillips #0 screwdriver that are located under each rubber circle.
  • Remove the four rubber circles using the spudger located on each corner of the laptop.

  • Remove the four screws (Length: 7.7 mm) using the Phillips #0 screwdriver that are located under each rubber circle.

Add Comment

Slowly peel off the plastic covering around the screen. Place it to the side once it is completely disconnected.
  • Slowly peel off the plastic covering around the screen.

  • Place it to the side once it is completely disconnected.

  • You may need to apply slight pressure to release the clips of the covering.

Add Comment

Remove the two screws (Length: 7.7 mm) using the Phillips #0 screwdriver that hold the Webcam in place. Gently pull the webcam away from the laptop. Slowly disconnect the two ribbon cable connectors by sliding them towards the wire to disconnect the webcam from the laptop.
  • Remove the two screws (Length: 7.7 mm) using the Phillips #0 screwdriver that hold the Webcam in place.

  • Gently pull the webcam away from the laptop.

  • Slowly disconnect the two ribbon cable connectors by sliding them towards the wire to disconnect the webcam from the laptop.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tiffani Beck

Member since: 03/20/2017

219 Reputation

2 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 98