Difficulty
Difficult
Steps
10
Time Required
20 - 30 minutes
- Tape Transport Unit 10 steps
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Introduction
In order to keep your device in working order, the tape transport unit may need to be replaced.
Parts
No parts required.
-
Remove the eight (8) Phillips #00 screws. There are six (6) screws on the bottom of the camera and two (2) screws beneath the back light button.
-
Remove the five (5) Phillips #00 cassette side screws.
-
Remove the three (3) Phillips #00 screws located on the top of the lens side cover.
-
Remove the Phillips #00 screw holding the microphone on.
-
Remove the two (2) Phillips #00 screws from lens side cover.
-
Slide the lens side cover away from camera.
-
Remove the Phillips #00 screw from the tape transport slider.
-
Remove the four (4) Phillips #00 screws located on the top of the camera.
-
Remove the electrical connector from camera.
-
The tape transport unit is now free from the camera.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
UW Stout, Team 1-4, Zhou Fall 2011 Member of UW Stout, Team 1-4, Zhou Fall 2011
UWSTOUT-ZHOU-F11S1G4
5 Members
5 Guides authored
