Sony DSC-RX10M3 Back and Right Panel Replacement
Salman Hersi and 4 other contributors
Last updated on May 7, 2024
Views: 2.1K
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 27
- Past 30 Days:
- 92
- All Time:
- 2,126
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 3 4
3 people have marked this guide "completed." Will you be next?
4 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This guide is an important pre-requisite that is required to replace the Sony DSC-RX10M3 LCD and viewfinder. You will find in this guide the important steps required to make sure that you properly remove the back casing which exposes the motherboard of the device.
What you need
Tools
-
-
-
Turn off the Device by scrolling the tab to "OFF" indicated by the arrow.
Ask FixBot
-
-
-
-
-
Remove the twelve 0.7mm Phillips #000 screws from the bottom case.
-
-
-
-
Remove the two 0.7mm screws that secure the right side of the camera.
-
Remove the two 0.7mm screws that secure the left side of the camera, near the Wi-Fi logo and charging port.
-
-
-
Use a Phillips #000 screwdriver to remove the four 0.4mm screws located under the rubber eye guard.
-
Use a plastic opening tool to detach the back panel of the camera.
-
-
Tool used on this step:Tweezers$4.99
-
Using tweezers, disconnect the ribbon cable connecting the LCD to the circuit board.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Team
York University, Team S4-G4, Woodhouse Winter 2020 Member of York University, Team S4-G4, Woodhouse Winter 2020
YORK-WOODHOUSE-W20S4G4
3 Members
36 Guides authored
