Magellan RoadMate 1200 GPS Sensor Replacement
Ross Light and 5 other contributors
Last updated on May 14, 2019
Views: 3.8K
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 16
- Past 30 Days:
- 85
- All Time:
- 3,784
Comments: 5
5 comments on steps.
Completed: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Incorrect Tools
Help make this guide better by using the correct tools in images and/or text.
Community-Contributed Guide
An awesome member of our community made this guide. It was not created by iFixit staff.
Missing Prerequisites
This guide is missing information on how to start the process. Make a prerequisite guide!
Introduction
Go to step 1 ↓A guide to accessing the GPS sensor.
What you need
Tools
-
-
-
Remove the four rubber caps from the back by using the Phillips #00 screwdriver.
Ask FixBot
-
-
-
Remove the four screws holding the cover in place by using the Phillips #00 screwdriver.
-
-
-
Remove the back cover from the device by separating the back cover along its seam.
-
-
-
-
-
Remove the two screws on that are located on opposite sides of the board.
-
-
-
-
Lift up the circuit board and disconnect the GPS wire, pulling horizontally from its connector port.
-
-
-
-
-
Carefully flip the circuit board out so you can get to the sensor easily.
-
Remove the tape holding the sensor to the display and take out the sensor.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
