Introduction

This could be a solution to the buttons on the back of the camera not working. This is an easy replacement. Just be careful with the ribbons.

Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom. Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom. Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.
  • Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.

Add Comment

Take off the front part of the case with a plastic opening tool. Take off the front part of the case with a plastic opening tool. Take off the front part of the case with a plastic opening tool.
  • Take off the front part of the case with a plastic opening tool.

Add Comment

Pull off the two silver side pieces on the left and right sides. Pull off the two silver side pieces on the left and right sides.
  • Pull off the two silver side pieces on the left and right sides.

Add Comment

Remove the main back piece. It should easily lift off. Remove the main back piece. It should easily lift off.
  • Remove the main back piece. It should easily lift off.

Add Comment

Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease. Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease. Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.
  • Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.

Add Comment

Flip over the control board then use tweezers to pull out the ribbon connecting the circuit board to the motherboard. Flip over the control board then use tweezers to pull out the ribbon connecting the circuit board to the motherboard.
  • Flip over the control board then use tweezers to pull out the ribbon connecting the circuit board to the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Douglas Howe

Member since: 01/08/2015

474 Reputation

4 Guides authored

Team

USF Tampa, Team 9-4, Blackwell Winter 2015 Member of USF Tampa, Team 9-4, Blackwell Winter 2015

USFT-BLACKWELL-W15S9G4

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 8

All Time: 242