Parts

No parts required.

Introduction

This guide will show you how to access the LCD screen in order to repair or replace the screen.

Image 1/1: Remove both batteries.
  • Remove Memory Stick Pro from the card reader slot on the bottom of the camera.

  • Remove both batteries.

Add Comment

Image 1/2: Remove the two screws that are adjacent to the warning label, which is on the underside of the camera. Image 2/2: Do '''NOT''' remove all four screws from the bottom.
  • Remove the single visible screw from both sides of the camera.

  • Remove the two screws that are adjacent to the warning label, which is on the underside of the camera.

  • Do NOT remove all four screws from the bottom.

Add Comment

Image 1/2: The first time the case is removed, it will be stiff. Be patient and gently rock the cover back and forth until it slides free. Image 2/2: The first time the case is removed, it will be stiff. Be patient and gently rock the cover back and forth until it slides free.
  • Gently remove the back cover from the camera.

  • The first time the case is removed, it will be stiff. Be patient and gently rock the cover back and forth until it slides free.

Add Comment

Image 1/2: Image 2/2:
  • Remove the two screws holding the circuit board down.

Add Comment

Image 1/1: Use a thin object, like a paperclip, to gently pry the cable off the connector.
  • Detach the orange cable from the board.

  • Use a thin object, like a paperclip, to gently pry the cable off the connector.

Add Comment

Image 1/2: Slide LCD screen from the two slots. Image 2/2: Do not attempt to completely remove the screen, as it is still attached to the camera.
  • The LCD screen sits in two slots; one on the bottom, and one on the left edge.

  • Slide LCD screen from the two slots.

  • Do not attempt to completely remove the screen, as it is still attached to the camera.

Add Comment

Image 1/3: If needed, replace the LCD screen. Image 2/3: If needed, replace the LCD screen. Image 3/3: If needed, replace the LCD screen.
  • To remove the LCD screen, detach the orange cable from the board.

  • If needed, replace the LCD screen.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Thomas

Member since: 04/14/2010

64 Reputation

6 Guides authored

Team

Cal Poly, Team 15-50, Garner Spring 2010 Member of Cal Poly, Team 15-50, Garner Spring 2010

CPSU-GARNER-S10S15G50

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 14

Past 30 Days: 36

All Time: 9,671