Introduction

This simple 2 step guide will show you how to remove the front panel in order to maintain or replace it.

Parts

No parts required.

Remove all seven black 4 mm Philips #00 screws holding the front panel into place. Two on each of the sides of the camera and three on the bottom. Remove all seven black 4 mm Philips #00 screws holding the front panel into place. Two on each of the sides of the camera and three on the bottom.
  • Remove all seven black 4 mm Philips #00 screws holding the front panel into place. Two on each of the sides of the camera and three on the bottom.

Add Comment

Gently lift the front panel up off the back of the camera prying up around the edges using a plastic opening tool or spudger if necessary. Gently lift the front panel up off the back of the camera prying up around the edges using a plastic opening tool or spudger if necessary. Gently lift the front panel up off the back of the camera prying up around the edges using a plastic opening tool or spudger if necessary.
  • Gently lift the front panel up off the back of the camera prying up around the edges using a plastic opening tool or spudger if necessary.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Daniel Surgenor

Member since: 01/23/2015

201 Reputation

2 Guides authored

Team

UWT Liner: Group 4 Member of UWT Liner: Group 4

Community

6 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 80