Introduction

Is your LCD screen acting strange? Replacing the CCD Sensor Module is a straight forward task that will increase the clarity of your screen.

Parts

No parts required.

Locate the battery cover on the bottom of the camera. Push down on the door and then, while pushing down, slide it back.  It will pop open. Locate the battery cover on the bottom of the camera. Push down on the door and then, while pushing down, slide it back.  It will pop open.
  • Locate the battery cover on the bottom of the camera. Push down on the door and then, while pushing down, slide it back. It will pop open.

Add Comment

Remove the exposed battery.
  • Remove the exposed battery.

Add Comment

Use a PH00 screw driver to remove the six 2.9mm phillips screws holding the back cover in place. There are two screws on the left and right sides of the camera, and two screws on the bottom. Use a PH00 screw driver to remove the six 2.9mm phillips screws holding the back cover in place. There are two screws on the left and right sides of the camera, and two screws on the bottom. Use a PH00 screw driver to remove the six 2.9mm phillips screws holding the back cover in place. There are two screws on the left and right sides of the camera, and two screws on the bottom.
  • Use a PH00 screw driver to remove the six 2.9mm phillips screws holding the back cover in place. There are two screws on the left and right sides of the camera, and two screws on the bottom.

Add Comment

Gently pry the front casing away from the camera. Gently pry the front casing away from the camera.
  • Gently pry the front casing away from the camera.

Add Comment

Use the tip of a spudger to flip up the tab on the ZIF connector securing the motherboard ribbon cable. The second picture shows what these tabs look like in their open positions.
  • Use the tip of a spudger to flip up the tab on the ZIF connector securing the motherboard ribbon cable.

  • The second picture shows what these tabs look like in their open positions.

Add Comment

Grasp the CCD Sensor Module and remove it.
  • Grasp the CCD Sensor Module and remove it.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

iDeleted

Member since: 07/07/2010

701 Reputation

24 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 18

Past 30 Days: 65

All Time: 10,995