Skip to main content

Sony CPF-IP001 Subwoofer Housing Disassembly

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

What you need

  1. Sony CPF-IP001 Subwoofer Housing Disassembly, Subwoofer Housing Disassembly: step 1, image 1 of 2 Sony CPF-IP001 Subwoofer Housing Disassembly, Subwoofer Housing Disassembly: step 1, image 2 of 2
    • Remove fourteen 8 mm Phillips #2 screws from the bottom of the subwoofer.

    • Once all of the screws are removed, the cover can be taken off using a metal spudger.

  2. Sony CPF-IP001 Subwoofer Housing Disassembly: step 2, image 1 of 2 Sony CPF-IP001 Subwoofer Housing Disassembly: step 2, image 2 of 2
    • Remove eight 14 mm Phillips #2 screws holding the circuit board in place.

    • Using the plastic opening tool, carefully remove the circuit board.

    • There will be 3 wires connected to the opposite side of the circuit board. Be careful not to pull the board out of the device too far and damage these wires.

  3. Sony CPF-IP001 Subwoofer Housing Disassembly: step 3, image 1 of 2 Sony CPF-IP001 Subwoofer Housing Disassembly: step 3, image 2 of 2
    • Remove the first of the three wires by squeezing the clip and pulling it out.

    • After disconnecting the first wire, the two attached wires can be more easily accessed.

  4. Sony CPF-IP001 Subwoofer Housing Disassembly: step 4, image 1 of 3 Sony CPF-IP001 Subwoofer Housing Disassembly: step 4, image 2 of 3 Sony CPF-IP001 Subwoofer Housing Disassembly: step 4, image 3 of 3
    Tool used on this step:
    Tweezers
    $4.99
    Buy
    • Remove the wire furthest to the left by squeezing the clip and pulling it out.

    • Detach the third wire by carefully using the tweezers.

    • The circuit board is now completely detached and can be set aside.

  5. Sony CPF-IP001 Subwoofer Housing Disassembly: step 5, image 1 of 2 Sony CPF-IP001 Subwoofer Housing Disassembly: step 5, image 2 of 2
    • Remove six 8 mm Phillips #2 screws.

    • Slide the side panel with the power cord out from the housing.

    • The side panel with the power cord will come out as a whole unit with the subwoofer air tunnel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Mike Bolton

Member since: 04/14/15

473 Reputation

4 Guides authored

Team

Cal Poly, Team 6-14, Maness Spring 2015 Member of Cal Poly, Team 6-14, Maness Spring 2015

CPSU-MANESS-S15S6G14

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 77