Introduction

The back panel covers internal components. This guide will help remove it in order to access those components.

Parts

No parts required.

Use a Phillips head 000 screwdriver to remove the 4.0mm screw at the side opposite of the USB port.
  • Use a Phillips head 000 screwdriver to remove the 4.0mm screw at the side opposite of the USB port.

Add Comment

Use a Phillips head 000 screwdriver to remove the three 4.0mm screws on the bottom of the camera. Use a Phillips head 000 screwdriver to remove the three 4.0mm screws on the bottom of the camera.
  • Use a Phillips head 000 screwdriver to remove the three 4.0mm screws on the bottom of the camera.

Add Comment

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Tilt up the LCD screen.
  • Tilt up the LCD screen.

  • Use a Phillips head 000 screwdriver to remove the two coarse 4.0mm screws near the bottom of the camera.

Add Comment

Gently pry off the back panel, by wiggling it around the LCD screen.
  • Gently pry off the back panel, by wiggling it around the LCD screen.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jonathan Chen

Member since: 10/17/2017

607 Reputation

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 14

All Time: 104