Introduction

This guide provided instruction on removing the motherboard and should only be followed if a compatible replacement is available or subsequent repair procedures require its removal.

Parts

No parts required.

Remove the seven highlighted screws shown here. Screws are teeny tiny, don't lose them! Screws are teeny tiny, don't lose them!
  • Remove the seven highlighted screws shown here.

  • Screws are teeny tiny, don't lose them!

Remove this final screw from the memory card compartment. Remove the chassis by pulling the back cover away from the camera.
  • Remove this final screw from the memory card compartment.

  • Remove the chassis by pulling the back cover away from the camera.

Gently but forcefully lift up on the parallel cable connecting the two halves of the camera. Gently but forcefully lift up on the parallel cable connecting the two halves of the camera.
  • Gently but forcefully lift up on the parallel cable connecting the two halves of the camera.

After removing the backing from the camera. Remove the two final screws in the memory compartment area. Detach the facing for the memory dock.
  • After removing the backing from the camera. Remove the two final screws in the memory compartment area.

  • Detach the facing for the memory dock.

New Battery = Faster iPhone
Fix Kits starting at $16.99
Remove the eight screws securing the mount for the flash device. Remove the eight screws securing the mount for the flash device.
  • Remove the eight screws securing the mount for the flash device.

Remove the three remaining screws holding in the protective metal casing. Remove the three remaining screws holding in the protective metal casing.
  • Remove the three remaining screws holding in the protective metal casing.

Remove the metal casing.
  • Remove the metal casing.

Remove three screws holding down the motherboard .
  • Remove three screws holding down the motherboard .

Detach the nine serial cables connecting it to the camera body. Detach the nine serial cables connecting it to the camera body.
  • Detach the nine serial cables connecting it to the camera body.

Finally remove the motherboard from the casing.
  • Finally remove the motherboard from the casing.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Leonard Holloman

Member since: 08/31/2015

539 Reputation

4 Guides authored

Team

USF Tampa, Team 4-4, Meier Fall 2015 Member of USF Tampa, Team 4-4, Meier Fall 2015

USFT-MEIER-F15S4G4

4 Members

5 Guides authored

Then loose the plug all the motherboard?

kongre172 - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 7

Past 30 Days: 26

All Time: 901