Parts

No parts required.

Image 1/2: Remove the four 8mm screws attaching the stand to the TV. Image 2/2: Remove the four 8mm screws attaching the stand to the TV.
  • Place the TV face down on a flat smooth surface as to not scratch the screen.

  • Remove the four 8mm screws attaching the stand to the TV.

Add Comment

Image 1/2: Image 2/2:
  • Lift the stand off the television.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Remove the two back panels to display the audio and video inputs..

Add Comment

Image 1/2: Remove the two 6mm Phillips near the inputs. Image 2/2: Remove the two 6mm Phillips near the inputs.
  • Remove the eight 6mm Phillips screws around the edge.

  • Remove the two 6mm Phillips near the inputs.

Add Comment

Image 1/1:
  • Lift and remove the back case of the television.

Add Comment

Image 1/3: Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires. Image 2/3: Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires. Image 3/3: Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires.
  • Remove the two speaker cables and the connector from the circuit board by pinching the plastic connectors and firmly pulling up.

  • Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires.

Add Comment

Image 1/2: Remove the green/gray to orange/gray connector from the center of the circuit board. Image 2/2: Remove the green/gray to orange/gray connector from the center of the circuit board.
  • Remove the green and gray power connector from the side of the buttons panel at the top of the television.

  • Remove the green/gray to orange/gray connector from the center of the circuit board.

Add Comment

Image 1/2: Image 2/2:
  • Remove the four 5mm phillips screws attaching the LCD and circuit board to the front case.

Add Comment

Image 1/1:
  • Lift the circuit board/LCD block from the case by lifting the near side of the circuit board and sliding it under the button frame.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Robert Hobson

Member since: 01/20/2011

1,217 Reputation

9 Guides authored

Team

Cal Poly, Team 1-11, Amido Winter 2011 Member of Cal Poly, Team 1-11, Amido Winter 2011

CPSU-AMIDO-W11S1G11

4 Members

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 14

Past 30 Days: 51

All Time: 5,427