Introduction
This guide will inform users how to remove and replace the Shark Steam Pocket Mop power cable.
What you need
-
-
Begin by removing the 8 quarter inch phillips head screws found along the back panel
-
Once all 8 screws have been removed, gently remove the back panel from the rest of the mop's body
-
-
-
-
Start by removing the two 1/8th inch Phillips head screws with your Phillips head screwdriver.
-
Gently remove the small plastic piece holding the wires against the plastic midframe of the mop.
-
Next use your wire cutters to remove the two plastic connectors and replace those wires with your new ones.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
USF Tampa, Team S13-G7, Cagle Fall 2017 Member of USF Tampa, Team S13-G7, Cagle Fall 2017
USFT-CAGLE-F17S13G7
4 Members
10 Guides authored
