Skip to main content

Introduction

Replace the battery when the vacuum does not turn on even after charging.

Tools

No tools specified.

  1. Turn the device over to reveal the bottom of the motorized brush head.
    • Turn the device over to reveal the bottom of the motorized brush head.

  2. Slide the latch next to the panel upwards into the unlocked position. Slide the latch next to the panel upwards into the unlocked position.
    • Slide the latch next to the panel upwards into the unlocked position.

  3. Slide the panel to the right to reveal the battery.
    • Slide the panel to the right to reveal the battery.

  4. Pull the battery from the vacuum. Pull the battery from the vacuum.
    • Pull the battery from the vacuum.

  5. Disconnect the battery from the vacuum by pinching the white latch and pulling the two pieces apart. Disconnect the battery from the vacuum by pinching the white latch and pulling the two pieces apart.
    • Disconnect the battery from the vacuum by pinching the white latch and pulling the two pieces apart.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Zachary Liu

Member since: 01/24/2018

577 Reputation

5 Guides authored

Team

Cal Poly, Team S1-G5, Livingston Winter 2018 Member of Cal Poly, Team S1-G5, Livingston Winter 2018

CPSU-LIVINGSTON-W18S1G5

3 Members

5 Guides authored

6 Comments

How much is the part for the shark

sumi49 - Reply

My Shark SV1106 doesn’t stay on very long. One episode you turn it on it immediately turns off. So what is the issue?

jklab23 - Reply

How much is a battery pack?

ridgeite145 - Reply

How much is a new battery pack for replacement

ridgeite145 - Reply

I’m still waiting for a response. If I can’t submit an “empty comment” how am I supposed to get an answer?

ridgeite145 - Reply

Add Comment

View Statistics:

Past 24 Hours: 6

Past 7 Days: 29

Past 30 Days: 99

All Time: 8,232