Parts

No parts required.

Using the Phillips head screwdriver, remove the six screws on the bottom of the console. Using the Phillips head screwdriver, remove the six screws on the bottom of the console.
  • Using the Phillips head screwdriver, remove the six screws on the bottom of the console.

Add Comment

Remove the two screws that attach the Genesis' connector to the rest of the console.
  • Remove the two screws that attach the Genesis' connector to the rest of the console.

Add Comment

Slide the lock tab to the left to separate the halves of the console.
  • Slide the lock tab to the left to separate the halves of the console.

Add Comment

Lift from the left side to remove the top of the case.
  • Lift from the left side to remove the top of the case.

Add Comment

Using the spudger, pry the cover off of the Genesis attachment.
  • Using the spudger, pry the cover off of the Genesis attachment.

Add Comment

Lift the top of the case to remove the cover.
  • Lift the top of the case to remove the cover.

Add Comment

Remove the faceplate by pulling it up, then out.
  • Remove the faceplate by pulling it up, then out.

Add Comment

Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate. Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.
  • Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.

Add Comment

Remove the two screws from the plastic bar. Remove the two screws from the plastic bar.
  • Remove the two screws from the plastic bar.

Add Comment

To remove the CD tray, remove the four screws with the Phillips head screwdriver. To remove the CD tray, remove the four screws with the Phillips head screwdriver.
  • To remove the CD tray, remove the four screws with the Phillips head screwdriver.

Add Comment

Carefully unplug the wire connected to optical reader.
  • Carefully unplug the wire connected to optical reader.

Add Comment

Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver. The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws. Carefully remove the CD tray from circuit board.
  • Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver.

  • The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws.

  • Carefully remove the CD tray from circuit board.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

sskyllin

Member since: 10/18/2010

21 Reputation

2 Guides authored

Team

Cal Poly, Team 5-14, Maness Fall 2010 Member of Cal Poly, Team 5-14, Maness Fall 2010

CPSU-MANESS-F10S5G14

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 38

All Time: 6,478