Introduction

This guide does not require any prerequisite steps. Flip open the phone and begin the guide.

Parts

No parts required.

  1. With the flat end of  a spudger, remove the plastic covers located on the corners of the display near the hinge and above the screen, revealing four screws underneath. With the flat end of  a spudger, remove the plastic covers located on the corners of the display near the hinge and above the screen, revealing four screws underneath.
    • With the flat end of a spudger, remove the plastic covers located on the corners of the display near the hinge and above the screen, revealing four screws underneath.

  2. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  3. Remove the 4.4mm screw in each corner using the Tri-wing Y0 screwdriver. Remove the 4.4mm screw in each corner using the Tri-wing Y0 screwdriver.
    • Remove the 4.4mm screw in each corner using the Tri-wing Y0 screwdriver.

  4. Carefully pry the screen protector off the phone using the flat end of the spudger. This will require a bit of force as the back of the screen protector is lined with an adhesive material.
    • Carefully pry the screen protector off the phone using the flat end of the spudger.

      • This will require a bit of force as the back of the screen protector is lined with an adhesive material.

    • Once free from the adhesive, pull the screen protector away from the phone.

Conclusion

To reassemble your device, follow these instructions in reverse order.

StephenYH

Member since: 03/11/2013

20 Reputation

3 Guides authored

Team

Clemson, Team 12-1, Benson Spring 2013 Member of Clemson, Team 12-1, Benson Spring 2013

CLEM-BENSON-S13S12G1

4 Members

20 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 205