1. Be sure to unplug the vacuum before disassembling it to prevent electric shock.
    • Be sure to unplug the vacuum before disassembling it to prevent electric shock.

    • Lay vacuum on side.

    • Using a Phillips screwdriver, unscrew the screw behind the front wheels, on the edge of the underside of the vacuum cleaner.

    Add Comment

  2. Stand the vacuum upright and identify the dial on the front of the vacuum.
    • Stand the vacuum upright and identify the dial on the front of the vacuum.

    • Unscrew the screw using a Torx 20 screwdriver

    • Pull the dial out.

    Add Comment

    • Lift the cover off of the vacuum.

    Add Comment

    • Identify the two gray metal plates at the front of the vacuum.

    • Using the T20 Torx screwdriver, remove the four screws on the smaller gray plate holding the larger gray metal plates.

    Add Comment

    • Remove the small metal plate with the black bolt in the center.

    • Repeat on opposite side near the other wheel

    Add Comment

    • Remove the larger gray metal plate.

    • Repeat on opposite side near other wheel.

    Add Comment

    • Remove the front wheels by lifting the silver bar that attaches the two wheels.

    • Detach the spring attaching the wheels to the vacuum.

    Add Comment

    • Remove a wheel from the wheel's axel by pulling off the wheel.

    • Slide spring off.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Caycie Pascual

Member since: 09/26/2012

1 Reputation

5 Guides authored

Team

Cal Poly, Team 16-58, Forte Fall 2012 Member of Cal Poly, Team 16-58, Forte Fall 2012

CPSU-FORTE-F12S16G58

5 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 686