Introduction

All you need for this guide is the will to fix your camera. Enjoy!

Check for debris and dust around the power button to make sure it's clean. If dust is absent, then begin with unscrewing the seven outside shell 4 mm Philips screws with the Philips screw driver. Now carefully pry open the back casing with the ifixit plastic opening tool.
  • Check for debris and dust around the power button to make sure it's clean.

  • If dust is absent, then begin with unscrewing the seven outside shell 4 mm Philips screws with the Philips screw driver.

  • Now carefully pry open the back casing with the ifixit plastic opening tool.

Add Comment

Now that you have the back casing off, gently remove the LCD screen from the camera. Next unscrew the three 4 mm Philips screws on the back panel with the same screw driver(See image).
  • Now that you have the back casing off, gently remove the LCD screen from the camera.

  • Next unscrew the three 4 mm Philips screws on the back panel with the same screw driver(See image).

Add Comment

Unclip the four connecters that hold down the orange copper film strips with the plastic opening tool. Then carefully pull out the three film strips with the ifixit tweezers.
  • Unclip the four connecters that hold down the orange copper film strips with the plastic opening tool.

  • Then carefully pull out the three film strips with the ifixit tweezers.

Add Comment

Remove the 4 mm Philip screw located above the center film strip with the Philips screw driver.  This will allow the top frame to come loose to take off.
  • Remove the 4 mm Philip screw located above the center film strip with the Philips screw driver. This will allow the top frame to come loose to take off.

Add Comment

Then pull back the black claw located at the bottom right of the camera, to the right with the plastic opening tool.  This holds the main plate down.
  • Then pull back the black claw located at the bottom right of the camera, to the right with the plastic opening tool. This holds the main plate down.

Add Comment

Slowly lift with your fingers, the top frame of the camera to get to the power button.
  • Slowly lift with your fingers, the top frame of the camera to get to the power button.

Add Comment

Replace power button with new one.
  • Replace power button with new one.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

chelsa

Member since: 03/03/2015

319 Reputation

3 Guides authored

Team

3 Tech Girls Member of 3 Tech Girls

Community

2 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 3

All Time: 150