1. Remove the 4 (4.7mm) philips head screws.
    • Remove the 4 (4.7mm) philips head screws.

    Add Comment

  2. Unplug the rubber charger outlet cover.
    • Unplug the rubber charger outlet cover.

    Add Comment

    • Unplug the rubber headset jack cover.

    Add Comment

    • Begin by inserting the pry tool near the charger jack.

    • There are 4 tabs to release.

      • Start at the bottom and slide the tool up, lifting the silver front of the phone away from the white backing.

    • Loosen the 2 side tabs before moving on to the top two.

    • See the second photo to see location of the tabs.

    • Be careful of the ribbon wires shown in second photo.

    Add Comment

    • Once the two side tabs are free; gently pry the white backing down to release the top two tabs.

    • Hold the phone with the left hand as shown

    • Wiggle the white backplate from side to side while pulling down with the right hand.

    • Be careful of the ribbon wires shown in second photo.

    Add Comment

    • Remove the ribbon wires connecting to the screen using the pry tool.

    Add Comment

    • 2 tabs hold the motherboard in place.

    • Release the labeled tabs with the pry tool from the location shown.

    Add Comment

    • Separate the motherboard from the phone.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Matthew Hove

Member since: 01/05/2011

1,031 Reputation

10 Guides authored

Team

Cal Poly, Team 3-40, Regan Winter 2011 Member of Cal Poly, Team 3-40, Regan Winter 2011

CPSU-REGAN-W11S3G40

4 Members

20 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 1,743