Introduction

This guide will explain how to successfully remove the screen underneath the outside shell and on top of the circuit board.

Parts

No parts required.

Image 1/3: Remove 2 screws from side of camera Image 2/3: Remove 2 screws from side of camera Image 3/3: Place Screws on magnetic surface or location where they will not roll away
  • Remove 4 screws from bottom of camera

  • Remove 2 screws from side of camera

  • Remove 2 screws from side of camera

    • Place Screws on magnetic surface or location where they will not roll away

Add Comment

Image 1/1:
  • Squeeze area noted by blue square and pull outside shell apart from remaining camera.

Add Comment

Image 1/1:
  • Remove two screws holding screen to circuit board marked by red circles

Add Comment

Image 1/3: Flip white peg up noted by blue box Image 2/3: Using tweezers gently remove orange circuit ribbon from white peg. Make sure white peg remains up otherwise ribbon may tear. Image 3/3: Using tweezers gently remove orange circuit ribbon from white peg. Make sure white peg remains up otherwise ribbon may tear.
  • Lift screen up such that orange circuit ribbon fully extends

  • Flip white peg up noted by blue box

  • Using tweezers gently remove orange circuit ribbon from white peg. Make sure white peg remains up otherwise ribbon may tear.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 276