Introduction
Removing the logic board from the Garmin Nuvi 200
What you need
-
-
-
Peel off the sticker from the bottom of the device to reveal two screws.
Ask FixBot
-
-
-
Insert a plastic opening tool in the gap between the front and rear casing.
-
Carefully work the tool around the gap, separating the two halves of the case.
-
-
-
-
-
-
Peel away the tape holding the ribbon cable in place.
-
Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.
-
-
-
Pull out the cable between the logic board and the speaker to disconnect them.
-
-
-
Remove the three screws from the logic board using the #00 Phillips screwdriver.
-
Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
Cal Poly, Team 25-90, Amido Spring 2010 Member of Cal Poly, Team 25-90, Amido Spring 2010
CPSU-AMIDO-S10S25G90
4 Members
60 Guides authored
