Samsung NP510R5E-A01UB Speaker Replacement

Step 1 Hard Drive

• Make sure the device is powered off before beginning.
• Using the Phillips #0 screwdriver, remove the 6.5mm long screw in the area circled.
Step 2

• With the cover removed, unscrew all four of the 4.75mm long screws using the Phillips #0 screwdriver.
Step 3
• Unplug the connector from the hard drive by pulling straight out.
Step 4 Speaker
• Remove the two rubber feet with arrows by them on the back side to uncover two screws.
• Unscrew the four silver 4.4mm long screws near the hard drive.
• Unscrew the remaining nine black 6.5mm long screws. Then remove the back casing using a pry tool if needed.
Step 5
• Untangle the wires attached to the exterior of the right speaker.
• Lift the tape up holding the wires down to fully release the wires.
Step 6
• Unscrew the 3.4mm long screw holding the right speaker in place.
Step 7
• Pull up on the wires circled to disconnect the right speaker.
Step 8
• Using the plastic opening tool, pry up the right speaker and take it out.
Step 9
• Unscrew the 3.4mm long screw holding the left speaker in place.
Step 10
• Pull up on the wires to disconnect the left speaker.
Step 11
• Using the plastic opening tool, pry up the left speaker and take it out.

Author

with 1 other contributor

Brian Briggs

Member since: 02/14/18

529 Reputation

4 Guides authored

Badges: 9

• 
• 
• 

+6 more badges

Team

USF Tampa, Team S6-G5, Eyestone Spring 2018 Member of USF Tampa, Team S6-G5, Eyestone Spring 2018

USFT-EYESTONE-S18S6G5

3 Members

8 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview