Introduction

This guide will demonstrate eight steps on how to replace the flip screen on a Samsung MV900F Smart Camera.

  1. Slide the lock towards the middle of the camera, in the same direction of the arrow.
    • Slide the lock towards the middle of the camera, in the same direction of the arrow.

    Add Comment

  2. Push the blue battery holder up in the direction of the arrow.
    • Push the blue battery holder up in the direction of the arrow.

    Add Comment

    • Pull the battery out of the battery slot.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use tweezers to remove the four rubber screw covers.

    Add Comment

    • Remove the four Phillips 2.381 mm screws on back side of camera and one Phillips 2.381 mm screw on the bottom of the camera, using a Phillips #00 screwdriver.

    Add Comment

    • Remove the back casing by just carefully pulling the casing off of the camera.

    Add Comment

    • Use the Phillips #00 screw driver to remove the four 2.381 mm screws next to the screen hinge.

    Add Comment

    • Use plastic opening tool to disconnect screen connector from the control board.

    Add Comment

    • Remove the old screen.

    Add Comment

Conclusion

To reassemble your device, follow these steps in reverse order.

Ethan Rowland

Member since: 03/03/2015

201 Reputation

2 Guides authored

One Comment

Anyone an Idea where I can buy a cheap new display for that cam?

Bernhard Prieler - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 9

All Time: 468