Introduction

Before replacing the lens, make sure to open the lens cover (use the switch on the side of the lens) for a better look at the scratched or dirty lens. If you suspect the lens is just dusty and in need of cleaning, replacing the lens is not necessary.

Parts

No parts required.

Image 1/1:
  • Remove the 4 mm screw on the underside of the camcorder near the tripod mount.

Add Comment

Image 1/1:
  • Remove the 4 mm screw next to the buckle of the hand strap closest to the lens.

Add Comment

Image 1/1:
  • Open the LCD screen. Remove the 4 mm screw on the inside panel, located at top left corner.

Add Comment

Image 1/1: Be sure to remove the front casing at gently as possible to prevent damaging the attached ribbon cable. If not careful, the ribbon cables could be torn.
  • Firmly grip and pull the front casing on the lens to remove it.

  • Be sure to remove the front casing at gently as possible to prevent damaging the attached ribbon cable. If not careful, the ribbon cables could be torn.

Add Comment

Image 1/1:
  • Remove the three 5 mm screws surrounding the lens.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Renee

Member since: 03/11/2015

219 Reputation

2 Guides authored

Team

Marist, Team 1-5, Laflen Spring 2015 Member of Marist, Team 1-5, Laflen Spring 2015

MARS-LAFLEN-S15S1G5

3 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 248