Introduction

Cracked or faulty LCD screens can make the HMX-F90 difficult to use. This guide can be used to replace the flip-out LCD screen.

  1. Rotate the camcorder so that back is facing you. Then flip open the LCD screen.
    • Rotate the camcorder so that back is facing you. Then flip open the LCD screen.

    • Locate and remove the 4.5mm Phillips #00 screws in the LCD screen base.

    Add Comment

  2. Close the LCD screen. Then lift the silver base away from the camcorder.
    • Close the LCD screen. Then lift the silver base away from the camcorder.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Rotate the camcorder so that it is facing you.

    • Locate and remove the two 4.5mm Phillips #00 screws.

    Add Comment

    • Open the LCD screen and rotate it around 90 degrees.

    • Locate the small prying notch and use a prying tool to slowly remove the LCD cover.

    Add Comment

    • Locate and remove the two 3.5mm Phillips #00 screws holding the back cover.

    Add Comment

    • With tweezers gently unclip the silver tab holding the ribbon wire.

    • Gradually feed the ribbon wire through the hole to remove the screen.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Amir Harb

Member since: 09/26/2017

625 Reputation

6 Guides authored

Team

USF Tampa, Team S13-G1, Boczar Fall 2017 Member of USF Tampa, Team S13-G1, Boczar Fall 2017

USFT-BOCZAR-F17S13G1

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 23

All Time: 240