Introduction

If your device is unable to read your SD card, you may need to replace your port. This guide will show you how to safely replace your SD port.

  1. Turn off your device before starting your repair.
    • Turn off your device before starting your repair.

    • Carefully remove the back cover with the plastic opening tool.

    • It is best to start with one corner and work your way around the device slowly.

    Add Comment

  2. Pop up the orange tab connected to the SD port with the plastic opening tool.
    • Pop up the orange tab connected to the SD port with the plastic opening tool.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the one 3mm Phillips #00 screw connected to the SD port.

    Add Comment

    • Pop open the orange wire tab connected to the SD port with the plastic opening tool.

    • If there is tape covering your tab, remove it with the tweezers before you pop open the tab.

    Add Comment

    • Using the orange tab, pull the SD port up and away from the device.

    Add Comment

    • Using the plastic end of the tweezers pop up the orange tab connecting the SD port to the device.

    • There is a little indent below the orange tab to help get under this piece. It may be difficult to remove, push up hard.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 17

All Time: 178