Introduction

This replacement is needed when your phone's speaker is bad.

Remove the back cover of phone by lifting up on the back cover tab with  the blue plastic opening tool. Go around the edge of the back cover to completely remove it. Go around the edge of the back cover to completely remove it.
  • Remove the back cover of phone by lifting up on the back cover tab with the blue plastic opening tool.

  • Go around the edge of the back cover to completely remove it.

Add Comment

Remove the old battery by lifting up on  the thumb tab. Periodically clean the brass terminals on the battery and the phone. Place a minute amount of ISO on a Q-tip and gingerly clean the connections. Periodically clean the brass terminals on the battery and the phone. Place a minute amount of ISO on a Q-tip and gingerly clean the connections.
  • Remove the old battery by lifting up on the thumb tab.

  • Periodically clean the brass terminals on the battery and the phone. Place a minute amount of ISO on a Q-tip and gingerly clean the connections.

Add Comment

Remove the nine 4mm screws screws from the midframe with a PH000 screw driver Remove the nine 4mm screws screws from the midframe with a PH000 screw driver Remove the nine 4mm screws screws from the midframe with a PH000 screw driver
  • Remove the nine 4mm screws screws from the midframe with a PH000 screw driver

Add Comment

Wedge the blue plastic opening tool in between the front and side panel. Move the blue plastic opening tool around the edges between the front and side panel.
  • Wedge the blue plastic opening tool in between the front and side panel.

  • Move the blue plastic opening tool around the edges between the front and side panel.

Add Comment

Make sure that you detach the mid-frame from the inside too. Make sure that you detach the mid-frame from the inside too.
  • Make sure that you detach the mid-frame from the inside too.

Add Comment

Use the plastic opening tool to unhook the ribbon cable clip. Use the plastic opening tool to unhook the ribbon cable clip.
  • Use the plastic opening tool to unhook the ribbon cable clip.

Add Comment

Gently pull on the connector with the tweezers until the speaker comes off. Gently pull on the connector with the tweezers until the speaker comes off.
  • Gently pull on the connector with the tweezers until the speaker comes off.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

14 other people completed this guide.

Kyle Ruff

Member since: 02/04/2016

4,435 Reputation

5 Guides authored

Team

USF Tampa, Team 17-3, Blackwell Winter 2016 Member of USF Tampa, Team 17-3, Blackwell Winter 2016

USFT-BLACKWELL-W16S17G3

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 50

Past 30 Days: 219

All Time: 3,523