Skip to main content

Fix Your Stuff

Right to Repair

Store

Introduction

Replace the display assembly complete with frame in your Samsung Galaxy A20.

  1. Remove the SIM/SD tray. Remove the SIM/SD tray.
    • Remove the SIM/SD tray.

  2. Release the back cover with the help of a thin blade or a Jimmy. Insert the tool between the frame display and the cover unclipping it along the entire perimeter. Release the back cover with the help of a thin blade or a Jimmy. Insert the tool between the frame display and the cover unclipping it along the entire perimeter.
    • Release the back cover with the help of a thin blade or a Jimmy. Insert the tool between the frame display and the cover unclipping it along the entire perimeter.

  3. Disconnect the Touch ID connector.
    • Disconnect the Touch ID connector.

  4. SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits

    SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits
  5. Using a Phillips screwdriver, remove the marked screws.
    • Using a Phillips screwdriver, remove the marked screws.

  6. Remove the upper and lower covers. Remove the upper and lower covers. Remove the upper and lower covers.
    • Remove the upper and lower covers.

  7. Pry up form their sockets and disconnect the following four connectors: battery, display, lower board and side buttons (power and volume). Remove the board ribbon cable.
    • Pry up form their sockets and disconnect the following four connectors: battery, display, lower board and side buttons (power and volume).

    • Remove the board ribbon cable.

    • Remove battery. If it's secured with adhesive, use a heat source to soften the adhesive.

  8. Disconnect the white wire and the blue wire. Lift the upper motherboard. Remove the glued-on microphone with the help of a heat source.
    • Disconnect the white wire and the blue wire.

    • Lift the upper motherboard.

    • Remove the glued-on microphone with the help of a heat source.

  9. Remove the glued-on vibration motor with the help of a heat source. Remove the lower motherboard. Remove the glued-on speaker with the help of a heat source.
    • Remove the glued-on vibration motor with the help of a heat source.

    • Remove the lower motherboard.

    • Remove the glued-on speaker with the help of a heat source.

  10. Once the speaker has been removed, move all the components on the new display assembly. If you own just the bare replacement display you need to remove the power/volume flat and separate the plastic frame from the display. If you own just the bare replacement display you need to remove the power/volume flat and separate the plastic frame from the display.
    • Once the speaker has been removed, move all the components on the new display assembly.

    • If you own just the bare replacement display you need to remove the power/volume flat and separate the plastic frame from the display.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Special thanks to these translators:

100%

These translators are helping us fix the world! Want to contribute?
Start translating ›

Smilzo

Member since: 11/09/2013

6,482 Reputation

36 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 31

Past 7 Days: 149

Past 30 Days: 674

All Time: 2,100