Introduction

If your keypad is malfunctioning by either inputting the wrong characters when you type or not recognizing when you click any of the buttons, then installing a new keypad may help.

Parts

No parts required.

To remove the back casing, firmly press down and push towards the bottom of the phone.
  • To remove the back casing, firmly press down and push towards the bottom of the phone.

Add Comment

With the casing removed, lift the battery from the indicated indentation.
  • With the casing removed, lift the battery from the indicated indentation.

Add Comment

  • From here, you can now access the SIM card and model/serial numbers.

Add Comment

  • Using the Phillips #00 screwdriver, remove the four indicated screws (4.5 mm).

Add Comment

  • Press the pointed edge of the spudger into the side of the two rubber plugs in order to lift and remove them from the top of the phone.

  • Then, using the Phillips #00 screwdriver, remove the two indicated Phillip screws (6.5 mm).

Add Comment

  • To remove the SIM card, start by pressing the top of the card and push down and away towards the bottom of the phone. Then, as indicated, pull the SIM card out.

Add Comment

  • Begin to slowly lift the back casing of the phone. You should hear a snap when the casing is released.

  • The power, volume, and camera buttons may fall out when separating the front and back casing.

Add Comment

  • Your casing should be separated and the three loose buttons put to the side.

  • Be aware of the wiring on the top of the phone. Make sure not to pull it apart when separating the case.

Add Comment

  • Slowly remove the back casing by gently pulling the ribbon connection.

Add Comment

  • Gently pull on the wires to remove the front casing.

Add Comment

  • Your front casing and front speaker are now released.

Add Comment

  • Remove the keypad and place it to the side.

Add Comment

  • Insert the flat edge of the spudger to the space under the keypad and slide it along the bottom to lift the keypad out of its place. The keypad should be stuck to the surface very tightly.

Add Comment

  • The keypad will lift off the adhesive.

  • Be aware of the wires still connected on the right side of the phone.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Garrett Germany

Member since: 04/15/2012

24 Reputation

2 Guides authored

Team

Cal Poly, Team 6-24, Amido Spring 2012 Member of Cal Poly, Team 6-24, Amido Spring 2012

CPSU-AMIDO-S12S6G24

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 767