Skip to main content

Introduction

This guide will show you how to properly install a new blade to your Ryobi CSB125 circular saw. When performing cuts, if there is a burning smell then most likely the blade is either dirty or dull. In this case, the blade should be replaced with a new one. This troubleshooting page will help diagnose any potential problems occurring due to a faulty blade. In the event that a new blade is needed, this guide will show the steps to properly install a new one. The only tool you will need is a 7”/32 allen key.

Parts

No parts specified.

  1. Place the saw down on a flat surface with the blade facing up.
    • Place the saw down on a flat surface with the blade facing up.

    • Make sure that the saw is unplugged from any power source.

  2. Use the 7”/32 allen key to loosen the 5/16-18 x 9/16 in. blade screw. Use the 7”/32 allen key to loosen the 5/16-18 x 9/16 in. blade screw.
    • Use the 7”/32 allen key to loosen the 5/16-18 x 9/16 in. blade screw.

  3. Remove the 5/16-18 x 9/16 in. blade screw, spring washer, and the outer blade washer.
    • Remove the 5/16-18 x 9/16 in. blade screw, spring washer, and the outer blade washer.

  4. Remove the blade from the saw.
    • Remove the blade from the saw.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Curtis Melo

Member since: 10/31/2019

1,012 Reputation

5 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 15

All Time: 424