Introduction

In this guide, we will show you how to replace the circuit board inside your Roku XD remote control.

Parts

No parts required.

Image 1/2: Remove the battery cover. Image 2/2: Remove the two AA batteries.
  • Take care when handling components. Circuit boards, soldering points, and other areas may have sharp points.

  • Remove the battery cover.

  • Remove the two AA batteries.

Add Comment

Image 1/2: Gently twist the spudger to separate the top and bottom halves of the remote. Image 2/2: Gently twist the spudger to separate the top and bottom halves of the remote.
  • Insert flat edge of spudger into seam between the top and bottom halves of the remote control.

  • Gently twist the spudger to separate the top and bottom halves of the remote.

Add Comment

Image 1/1:
  • Gently use the spudger to pry the circuit board loose.

Add Comment

Image 1/1:
  • Using either end of the spudger, gently lift and remove the clear keypad backing.

Add Comment

Image 1/1:
  • Using either end of the spudger, lift and remove the rubber keypad.

Add Comment

Image 1/1: Be sure to dispose of the faulty circuit board properly.  Recycle if possible!
  • Now that the remote is disassembled, you simply need to reassemble the remote using the replacement circuit board.

  • Be sure to dispose of the faulty circuit board properly. Recycle if possible!

Add Comment

Conclusion

To reassemble the remote once you've replaced the circuit board, return to the remote control disassembly page and follow the steps in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 9

All Time: 393