Skip to main content

Introduction

Prerequisite Only

Parts

No parts specified.

  1. Take care when handling components.  Circuit boards, soldering points, and other areas may have sharp points. Remove the battery cover.
    • Take care when handling components. Circuit boards, soldering points, and other areas may have sharp points.

    • Remove the battery cover.

    • Remove the two AA batteries.

  2. Insert flat edge of spudger into seam between the top and bottom halves of the remote control. Gently twist the spudger to separate the top and bottom halves of the remote.
    • Insert flat edge of spudger into seam between the top and bottom halves of the remote control.

    • Gently twist the spudger to separate the top and bottom halves of the remote.

  3. Gently use the spudger to pry the circuit board loose.
    • Gently use the spudger to pry the circuit board loose.

  4. Using either end of the spudger, gently lift and remove the clear keypad backing.
    • Using either end of the spudger, gently lift and remove the clear keypad backing.

  5. Using either end of the spudger, lift and remove the rubber keypad.
    • Using either end of the spudger, lift and remove the rubber keypad.

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 721