Introduction

Use this guide to replace a damaged or malfunctioning battery terminal in the Roku XD 2050X remote control. To complete this guide, you will need to disassemble your remote and use a soldering iron to replace the terminal.

Parts

No parts required.

Take care when handling components.  Circuit boards, soldering points, and other areas may have sharp points. Remove the battery cover.
  • Take care when handling components. Circuit boards, soldering points, and other areas may have sharp points.

  • Remove the battery cover.

  • Remove the two AA batteries.

Add Comment

Insert flat edge of spudger into seam between the top and bottom halves of the remote control. Gently twist the spudger to separate the top and bottom halves of the remote.
  • Insert flat edge of spudger into seam between the top and bottom halves of the remote control.

  • Gently twist the spudger to separate the top and bottom halves of the remote.

Add Comment

Deck the Halls
With tools and Fix Kits
Gently use the spudger to pry the circuit board loose.
  • Gently use the spudger to pry the circuit board loose.

Add Comment

Using either end of the spudger, gently lift and remove the clear keypad backing.
  • Using either end of the spudger, gently lift and remove the clear keypad backing.

Add Comment

Using either end of the spudger, lift and remove the rubber keypad.
  • Using either end of the spudger, lift and remove the rubber keypad.

Add Comment

Desolder the contacts for the battery terminals.
  • Desolder the contacts for the battery terminals.

  • Remove the battery terminals from the circuit board.

  • For hep with soldering view the ifixit soldering guide.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 10

All Time: 399