Introduction

In this guide, we'll show you how to replace the motherboard in your Roku XD 2050X.

Parts

No parts required.

Image 1/3: Take care when handling components.  Circuit boards, soldering points, and other areas may have sharp points. Image 2/3: Turn the device upside down. Image 3/3: Remove the two rubber pads using a plastic spudger.
  • Ensure the Roku XDis unplugged.

  • Take care when handling components. Circuit boards, soldering points, and other areas may have sharp points.

  • Turn the device upside down.

  • Remove the two rubber pads using a plastic spudger.

Add Comment

Image 1/2: Image 2/2:
  • Remove the two Phillips #1 9mm pan-head screws.

Add Comment

Image 1/3: Guide spudger around to loosen upper and lower frame to pry frame apart. Image 2/3: Gently remove upper frame. Image 3/3: Gently remove upper frame.
  • Insert spudger between upper and lower frame underneath the port access.

  • Guide spudger around to loosen upper and lower frame to pry frame apart.

  • Gently remove upper frame.

Add Comment

Image 1/2: Image 2/2:
  • Remove the two Phillips #1 8mm pan-head screws.

Add Comment

Image 1/1: Lift the motherboard out of the lower frame.
  • On the side of the board opposite the ports, find and tilt back the tab securing the board in place.

  • Lift the motherboard out of the lower frame.

Add Comment

Image 1/1: Be sure to dispose of the faulty motherboard properly.  Recycle if possible!
  • Replace the faulty motherboard with the new motherboard.

  • Be sure to dispose of the faulty motherboard properly. Recycle if possible!

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 16

Past 30 Days: 73

All Time: 2,151