Introduction

All individual parts can be replaced on the motherboard as well. Please see additional guides if needed.

Parts

No parts required.

Image 1/1:
  • Place the Roku 3 on the table face down and orient it so you can correctly read the writing.

Add Comment

Image 1/3: Repeat with the bottom right corner and bottom left corner. Image 2/3: Repeat with the bottom right corner and bottom left corner. Image 3/3: Repeat with the bottom right corner and bottom left corner.
  • Pull back the rubber protection in the top right corner to locate the screw.

  • Repeat with the bottom right corner and bottom left corner.

Add Comment

Image 1/1:
  • Remove the 9 mm screws from the three corners with a Hex 1.3 Screwdriver.

Add Comment

Image 1/2: Image 2/2:
  • Open the device by gently lifting the bottom half away from the top half of the device.

Add Comment

Image 1/1:
  • Use your fingers to carefully lift the motherboard from the top half of the device.

Add Comment

Image 1/2: Image 2/2:
  • Pull away the IO shield from the motherboard using your hands.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Samantha Miller

Member since: 10/06/2016

167 Reputation

1 Guide authored

Team

Cal Poly, Team 15-2, Livingston Fall 2016 Member of Cal Poly, Team 15-2, Livingston Fall 2016

CPSU-LIVINGSTON-F16S15G2

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 19

Past 30 Days: 92

All Time: 720