Heat up the iOpener for 30 seconds in the microwave and place across rubber pads on the back of the device.
  • Heat up the iOpener for 30 seconds in the microwave and place across rubber pads on the back of the device.

    • It may take multiple heats, left for a minute at a time, to properly loosen the glue.

Add Comment

Gently use the plastic opening tool to pry the rubber pads off.
  • Gently use the plastic opening tool to pry the rubber pads off.

Add Comment

Remove the four Phillips #000 screws from the bottom of the case.
  • Remove the four Phillips #000 screws from the bottom of the case.

Add Comment

Gently remove the under side of the device.
  • Gently remove the under side of the device.

Add Comment

Remove the middle component that is held in place by the top and bottom of the device.
  • Remove the middle component that is held in place by the top and bottom of the device.

Add Comment

Remove the cover over the A/V ports on the front of the device.
  • Remove the cover over the A/V ports on the front of the device.

Add Comment

Remove the board from the plastic enclosure.
  • Remove the board from the plastic enclosure.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Eric Rawls

Member since: 08/24/2015

294 Reputation

2 Guides authored

Team

USF Tampa, Team 1-5, Sullivan Fall 2015 Member of USF Tampa, Team 1-5, Sullivan Fall 2015

USFT-SULLIVAN-F15S1G5

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 21

All Time: 456