Fix Your Stuff Community Store

Roku 2 Case Replacement

Introduction

Replace the case of the device.

What you need

  1. Roku 2 Case Replacement, Case: step 1, image 1 of 1

    • Heat up the iOpener for 30 seconds in the microwave and place across rubber pads on the back of the device.

    • Note: It may take several heats, left for a minute at a time, to loosen the glue.

    Edit

  2. Roku 2 Case Replacement: step 2, image 1 of 1

    • Gently use the plastic opening tool to pry the rubber pads off.

    Edit

  3. Roku 2 Case Replacement: step 3, image 1 of 1

    • Use the 000 phillips to remove the screws found under all four of the rubber pads.

    Edit

  5. Roku 2 Case Replacement: step 4, image 1 of 1

    • Gently remove the under side of the device.

    Edit

  6. Roku 2 Case Replacement: step 5, image 1 of 1

    • Remove the middle component that is held in place by the top and bottom of the device.

    Edit

  7. Roku 2 Case Replacement: step 6, image 1 of 1

    • Remove the cover over the A/V ports on the front of the device.

    Edit

  8. Roku 2 Case Replacement: step 7, image 1 of 1

    • Remove the board from the plastic enclosure and put the board into the replacement enclosure.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Author

with 1 other contributor

Eric Rawls

Member since: 08/24/15

360 Reputation

2 Guides authored

Badges: 7

+4 more badges

Team

USF Tampa, Team 1-5, Sullivan Fall 2015 Member of USF Tampa, Team 1-5, Sullivan Fall 2015

USFT-SULLIVAN-F15S1G5

3 Members

7 Guides authored

One Comment

cause mine get’s hot and it’s slow as !&&*

brian price - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 4

All Time: 733