Roconia Q6 OK Button Replacement
Janki T and 3 other contributors
Last updated on Jun 27, 2024
Views: 351
View statistics:
- Past 24 Hours:
- 2
- Past 7 Days:
- 9
- Past 30 Days:
- 55
- All Time:
- 351
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This manual provides instructions for changing the Ronconia Q6 projector's OK button. The OK button is crucial for menu navigation and selection confirmation. Whether you're a novice or experienced, this guide offers straightforward, easy-to-follow steps to simplify the replacement process.
What you need
Tools
-
-
-
Flip your device upside down so that the interface is facing downwards.
Ask FixBot
-
-
-
The device is supported by rubber pieces located at the bottom extremities.
-
There are screws beneath the rubber pieces that can be removed. Remove all four 1.1 mm Phillips #1 screws by using the Phillips #0 screwdriver.
-
-
-
-
-
-
Use a Phillips #0 screwdriver to remove each of the 5.2 mm screws from the sensor board inside the cover.
-
-
-
Remove the motherboard and you will see the the pieces that help control the buttons.
-
Locate where the OK button is placed.
-
Remove the part that helps control the OK button by pulling it out
-
-
To reassemble your device, follow these instructions in reverse order.
Team
University of North Texas, Team 4-4, Harold Spring 2024 Member of University of North Texas, Team 4-4, Harold Spring 2024
UNT-HAROLD-S24S4G4
4 Members
72 Guides authored
