Introduction

Before beginning, double check that you have disconnected the power cable from the outlet. You will be taking out the base plate and replacing the power cable. You will need to cut the power cable and solder on the new one.

Remove the three 16mm Tri-Point screws from the base plate. Remove the three 16mm Tri-Point screws from the base plate.
  • Remove the three 16mm Tri-Point screws from the base plate.

Add Comment

Remove the base plate by pressing the plastic body away from the metal plate with your thumbs. Remove the base plate by pressing the plastic body away from the metal plate with your thumbs.
  • Remove the base plate by pressing the plastic body away from the metal plate with your thumbs.

Add Comment

Deck the Halls
With tools and Fix Kits
Remove the two 8mm Phillips screws from the plastic body.
  • Remove the two 8mm Phillips screws from the plastic body.

Add Comment

Pull the cord  and cut the black and red wires across the black heat shrink.
  • Pull the cord and cut the black and red wires across the black heat shrink.

  • Be careful when soldering the new power cable.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Luis Villalpando

Member since: 10/06/2016

113 Reputation

1 Guide authored

Team

Cal Poly, Team 10-6, Livingston Fall 2016 Member of Cal Poly, Team 10-6, Livingston Fall 2016

CPSU-LIVINGSTON-F16S10G6

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 49