Ridgid GEN5X R8611506 Foward / Reverse Selector Switch Replacement

Step 1 Outer Case



• Orient the drill to have the side with the screws facing up.
• Using the Torx T10 screwdriver, remove the eight 4.0mm screws from the face of the drill.
Step 2




• Orient the drill to where the back is facing up.
• Using a Torx T10 screwdriver, remove the four 6.0mm screws that attach the back piece to the drill.
• Remove the back piece of the drill using the iFixit opening tool.
Step 3
• Orient the drill to where the chuck is facing up.
• Using the Torx T15 screwdriver, remove the four 8.0mm screws from the front of the drill.
Step 4
• Orient the drill so the side with the screw holes is facing up.
• Use a plastic opening tool to gently pry the face off of the drill.
• Remove the face completely from the drill.
Step 5 Forward / Reverse Selector Switch
• Gently lift the trigger up.
• Unhook the selector switch from the trigger.
• Remove the selector switch.

Author

with 2 other contributors

Harrison Essary

Member since: 02/05/19

611 Reputation

6 Guides authored

Badges: 9

• 
• 
• 

+6 more badges

Team

Appalachian State University, Team S2-G4, Menagarishvili Spring 2019 Member of Appalachian State University, Team S2-G4, Menagarishvili Spring 2019

APSU-MENAGARISHVILI-S19S2G4

3 Members

12 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview