Introduction

Before starting this guide you may need some experience with soldering/ desoldering. If you do not know how, you can learn by clicking the link on step 5 (when you have to desolder the aluminum tabs).

Image 1/1: Remove any game in the console by opening the right latch and sliding the game to the right.
  • Before disassembling your Atari Lynx, be sure the device is powered off.

  • Remove any game in the console by opening the right latch and sliding the game to the right.

Add Comment

Image 1/1: Pinch the rear panel with your fingers and lift away from the Atari.
  • Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.

  • Pinch the rear panel with your fingers and lift away from the Atari.

Add Comment

Image 1/1: Be sure not to tear any wires attached to battery panel.
  • Remove battery panel by pinching the sides with your fingers and lifting away from the Atari.

  • Be sure not to tear any wires attached to battery panel.

Add Comment

Image 1/1: Be sure not to tear the speaker wire while removing the control panel.
  • Remove the control panel by pinching the sides with your fingers and lifting away from the Atari.

  • Be sure not to tear the speaker wire while removing the control panel.

Add Comment

Image 1/2: Image 2/2:
  • Desolder the four aluminum tabs and for more information on soldering click here.

Add Comment

Image 1/1:
  • Remove the aluminum back protector to gain access to the C10 capacitor.

Add Comment

Image 1/2: Image 2/2:
  • Desolder the C10 capacitor.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

John Lopez

Member since: 01/27/2014

440 Reputation

4 Guides authored

Team

Cal Poly, Team 1-42, Maness Winter 2014 Member of Cal Poly, Team 1-42, Maness Winter 2014

CPSU-MANESS-W14S1G42

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 6

Past 30 Days: 31

All Time: 2,200