Replacement Switch + Motor for Drill - Dexter Screwdriver UP20

Step 1 Switch + Motor
• Remove the battery and the mandrel. Loosen the screws with a T10 bit or a T10 screwdriver.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2
• Remove the top shell. Remove the battery connecter, the switch, the Engine + Gearbox assembly and then the LEDs. Detach the Engine from the Gearbox.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 3
• Assemble the new Switch + Motor assembly to the Gearbox. Position the LEDs.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 4
• Install the Engine + Gearbox assembly, the Switch and then the battery cover. Reposition the wiring.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 5
• Install the LED covers and then reposition the top shell.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 6
• Line the top shell.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Special thanks to these translators:

fr en

100%

HelloMacOS

HelloMacOS is helping us fix the world! Want to contribute?
Start translating ›

Author

with 1 other contributor

Antoine Lafillé

Member since: 01/30/20

945 Reputation

5 Guides authored

Badges: 8

• 
• 
• 

+5 more badges

Team

Leroy Merlin Member of Leroy Merlin

Community

36 Members

239 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview