Removing Nikon Coolpix 4600 Front and Rear case

You're viewing a previously published version of this guide. View latest version

Jul 30, 2014 - 04:28:37

Oct 19, 2023 - 03:48:13 Oct 11, 2023 - 10:50:41 Jun 11, 2020 - 05:35:54 Jul 30, 2014 - 04:28:37 Jan 28, 2014 - 02:50:41 Jul 31, 2013 - 04:40:08 Mar 08, 2013 - 11:57:23 May 31, 2012 - 02:41:08 May 31, 2012 - 02:41:04 May 27, 2012 - 04:22:12 May 27, 2012 - 04:18:09 May 27, 2012 - 04:18:04 May 27, 2012 - 04:15:07 May 24, 2012 - 11:34:05 May 24, 2012 - 11:31:22 May 24, 2012 - 11:24:01 May 11, 2012 - 02:20:18 May 11, 2012 - 02:19:42 May 10, 2012 - 11:44:17 May 08, 2012 - 01:46:59 May 08, 2012 - 01:46:57 May 08, 2012 - 01:45:43 May 08, 2012 - 01:45:42 May 08, 2012 - 01:38:15 May 08, 2012 - 01:38:14 May 08, 2012 - 01:36:03 May 08, 2012 - 01:36:01 May 08, 2012 - 01:25:42

Newer

Introduction

This installation guide will help you remove the rear and front casing of your Nikon Coolpix 4600.

What you need

Step 1 Front and Rear Case

Removing Nikon Coolpix 4600 Front and Rear case, Front and Rear Case: step 1, image 1 of 2

Removing Nikon Coolpix 4600 Front and Rear case, Front and Rear Case: step 1, image 2 of 2

Locate the six screws on the outside of the camera (2 3.3 mm on the bottom, 2 5.25 mm on the left, and 2 5.25 mm on the right).
Using a Phillips 00 screwdriver, remove all of the six screws.

Step 2

Carefully pull the front and back case apart.
The front case is attached to internal components and cannot be removed independently.

Step 3

Look closely at the connection between the ribbon cable and the motherboard. Locate the two grey tabs on either side of the connecting bracket.
Slide the grey tabs toward the bottom of camera. Gently disconnect the ribbon cable from the motherboard.
After disconnecting the data ribbon, you can now separate the back case from the front case.