Prerequisite Only
This is a prerequisite-only guide! This guide is part of another procedure and isn’t meant to be used alone.
Introduction
Go to step 1 ↓This guide shows how to apply the rear camera adhesive in your Google Pixel 8a.
What you need
Tools
-
Spudger4.9
-
-
-
-
If any rear camera conductive tape is still on the logic board, use tweezers to remove it.
-
Remove the replacement conductive tape from its plastic backing.
-
Carefully place the conductive tape so it connects the metal tab on the bottom right corner of the camera housing to the logic board.
-
Use the flat end of a spudger to firmly press the adhesive into place, securing it to the camera and logic board.
-
Remove the remaining liner.
-
-
-
To reassemble your device, follow these instructions in reverse order.